// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
/*
 * Copyright (c) 2024 Rockchip Electronics Co., Ltd.
 *
 */

/dts-v1/;

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/pinctrl/rockchip.h>
#include "rk3576.dtsi"
#include "rk3576-rk806.dtsi"

/ {
	model = "ArmSoM CM5 IO";
	compatible = "armsom,cm5", "rockchip,rk3576";

	sdio_pwrseq: sdio-pwrseq {
		compatible = "mmc-pwrseq-simple";
		pinctrl-names = "default";
		pinctrl-0 = <&wifi_poweren_gpio>;

		/*
		 * On the module itself this is one of these (depending
		 * on the actual card populated):
		 * - SDIO_RESET_L_WL_REG_ON
		 * - PDN (power down when low)
		 */
		post-power-on-delay-ms = <200>;
		reset-gpios = <&gpio1 RK_PC6 GPIO_ACTIVE_LOW>;
	};

	wireless_bluetooth: wireless-bluetooth {
		compatible = "bluetooth-platdata";
		//wifi-bt-power-toggle;
		uart_rts_gpios = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>;
		pinctrl-names = "default", "rts_gpio";
		pinctrl-0 = <&uart4m1_rtsn>;
		pinctrl-1 = <&uart4m1_rts_gpio>;
		BT,power_gpio = <&gpio1 RK_PC7 GPIO_ACTIVE_HIGH>;
		//BT,reset_gpio    = <&gpio3 RK_PC3 GPIO_ACTIVE_HIGH>;
		//BT,wake_host_irq = <&gpio1 RK_PC2 GPIO_ACTIVE_HIGH>;
		status = "okay";
	};

	wireless_wlan: wireless-wlan {
		compatible = "wlan-platdata";
		wifi_chip_type = "rtl8852bs";
		clocks = <&hym8563>; //如果使用hym8563，只能配置一个
		clock-names = "ext_clock";
		pinctrl-names = "default";
		pinctrl-0 = <&wifi_host_wake_irq>;
		WIFI,host_wake_irq = <&gpio0 RK_PB0 GPIO_ACTIVE_HIGH>;
		status = "okay";
	};
};

&cpu_l0 {
	cpu-supply = <&vdd_cpu_lit_s0>;
};

&cpu_b0 {
	cpu-supply = <&vdd_cpu_big_s0>;
};

&gpu {
	mali-supply = <&vdd_gpu_s0>;
	status = "okay";
};

&i2c2 {
	status = "okay";

	hym8563: hym8563@51 {
		compatible = "haoyu,hym8563";
		reg = <0x51>;
		#clock-cells = <0>;
		clock-frequency = <32768>;
		clock-output-names = "hym8563";
		pinctrl-names = "default";
		pinctrl-0 = <&hym8563_int>;
		interrupt-parent = <&gpio0>;
		interrupts = <RK_PA0 IRQ_TYPE_LEVEL_LOW>;
		wakeup-source;
	};
};

&iep {
	status = "okay";
};

&iep_mmu {
	status = "okay";
};

&jpegd {
	status = "okay";
};

&jpege {
	status = "okay";
};

&jpeg_mmu {
	status = "okay";
};

&mpp_srv {
	status = "okay";
};

&pinctrl {
	hym8563 {
		hym8563_int: hym8563-int {
			rockchip,pins = <0 RK_PA0 RK_FUNC_GPIO &pcfg_pull_up>;
		};
	};

	wireless-bluetooth {
		uart4m1_rts_gpio: uart4m1-rts-gpio {
			rockchip,pins = <1 RK_PC2 RK_FUNC_GPIO &pcfg_pull_none>;
		};
	};

	wireless-wlan {
		wifi_host_wake_irq: wifi-host-wake-irq {
			rockchip,pins = <0 RK_PB0 RK_FUNC_GPIO &pcfg_pull_down>;
		};

		wifi_poweren_gpio: wifi-poweren-gpio {
			rockchip,pins = <1 RK_PC6 RK_FUNC_GPIO &pcfg_pull_up>;
		};
	};
};

&rga2_core0 {
	status = "okay";
};

&rga2_core0_mmu {
	status = "okay";
};

&rga2_core1 {
	status = "okay";
};

&rga2_core1_mmu {
	status = "okay";
};

&rknpu {
	rknpu-supply = <&vdd_npu_s0>;
	status = "okay";
};

&rknpu_mmu {
	status = "okay";
};

&rkvenc_ccu {
	status = "okay";
};

&rkvenc0 {
	status = "okay";
};

&rkvenc0_mmu {
	status = "okay";
};

&rkvenc1 {
	status = "okay";
};

&rkvenc1_mmu {
	status = "okay";

};

&rkvdec {
	status = "okay";
};

&rkvdec_mmu {
	status = "okay";
};

&rockchip_suspend {
	status = "okay";
	rockchip,sleep-debug-en = <1>;

	rockchip,sleep-io-ret-config = <
		(0
		| RKPM_VCCIO3_RET_EN
		)
	>;

	rockchip,regulator-on-before-mem = <&vdd_npu_s0>;
};

&saradc {
	status = "okay";
	vref-supply = <&vcca_1v8_s0>;
};

&sdhci {
	bus-width = <8>;
	no-sdio;
	no-sd;
	non-removable;
	max-frequency = <200000000>;
	mmc-hs400-1_8v;
	mmc-hs400-enhanced-strobe;
	full-pwr-cycle-in-suspend;
	status = "okay";
};

&sdio {
	max-frequency = <200000000>;
	no-sd;
	no-mmc;
	bus-width = <4>;
	disable-wp;
	cap-sd-highspeed;
	cap-sdio-irq;
	keep-power-in-suspend;
	mmc-pwrseq = <&sdio_pwrseq>;
	non-removable;
	pinctrl-names = "default";
	pinctrl-0 = <&sdmmc1m0_bus4 &sdmmc1m0_clk &sdmmc1m0_cmd>;
	sd-uhs-sdr104;
	status = "okay";
};

&tsadc {
	status = "okay";
};

&uart4 {
	status = "okay";
	pinctrl-names = "default";
	pinctrl-0 = <&uart4m1_xfer &uart4m1_ctsn>;
};

&vdpp {
	status = "okay";
};

/* watchdog */
&wdt {
	status = "okay";
};